ELECTRICITY GENERATION FROM SEWAGE WASTEWATER IN A MICROBIAL FUEL CELL PILOT POWER PLANT USING ALUMINIUM CATHODES

Authors

  • Asia Saad Department of Mechanical Engineering, Jomo Kenyatta University of Agriculture and Technology/ Technical University of Mombasa, Faculty of Engineering and Technology
  • Hiram Ndiritu Department of Mechanical Engineering, Jomo Kenyatta University of Agriculture and Technology, Kenya
  • Meshack HawiMeshack Hawi Department of Mechanical Engineering, Jomo Kenyatta University of Agriculture and Technology, Kenya

Keywords:

SCMFC. Aluminium cathodes, Sewage wastewater, Microbial fuel cell pilot power plant

Abstract

Aluminium metal is a low-cost material which can be used as an alternative cathode to carbon-based electrodes, for oxygen reduction in microbial fuel cells (MFCs). This study showed the effect of using aluminium rods as cathodes and carbon rods as anodes in single chamber microbial fuel cells (SCMFCs) connected in series and parallel connections to form a pilot power plant for electricity generation. Each single cell generated an output voltage ranging between 0.5 to 0.7 V. The cells were arranged into two modules to increase the voltage and current in the system. Each module constituted of twenty-four cells connected in series. Module one generated a maximum output voltage of 13.72 V while module two generated 14.21 V. The two modules were then Connected in parallel to form the pilot power plant and increase the current in the system. The maximum output voltage obtained was 14.36 V and the maximum current was 3.5 mA when an external resistor of 815 Ω was connected in the system. The total working volume of sewage wastewater used in the system was 38.4 liters. The maximum power density obtained was 1281 W/m^3. The system was able to light DC bulbs, ranging from 3W and 5W. The results showed that SCMFCs using carbon rods as anode and aluminium rods as cathode can be connected in series to increase voltage and in parallel to increase the current, hence produce a good power output in watts.

References

[1] D. A. Jadhav, I. Das, M. M. Ghangrekar, and D. Pant, “Moving towards practical applications of microbial fuel cells for

sanitation and resource recovery,” 2020. doi: 10.1016/j.jwpe.2020.101566.

[2] P. Choudhury, R. N. Ray, T. K. Bandyopadhyay, B. Basak, M. Muthuraj, and B. Bhunia, “Process engineering for stable

power recovery from dairy wastewater using microbial fuel cell,” 2021. doi: 10.1016/j.ijhydene.2020.06.152.

[3] M. Mashkour, M. Rahimnejad, M. Mashkour, and F. Soavi, “Increasing bioelectricity generation in microbial fuel cells

by a high-performance cellulose-based membrane electrode assembly,” 2021. doi: 10.1016/j.apenergy.2020.116150.

[4] P. Dange et al., “A comprehensive review on oxygen reduction reaction in microbial Fuel cells,” J. Renew. Mater., vol.

10, no. 3, pp. 665–697, 2022, doi: 10.32604/jrm.2022.015806.J. V. Boas, V. B. Oliveira, M. Simões, and A. M. F. R.

Pinto, “Review on microbial fuel cells applications, developments and costs,” 2022. doi:

10.1016/j.jenvman.2022.114525.

[5] C. Munoz-Cupa, Y. Hu, C. Xu, and A. Bassi, “An overview of microbial fuel cell usage in wastewater treatment, resource

recovery and energy production,” 2021. doi: 10.1016/j.scitotenv.2020.142429.

[6] Y. Dessie, S. Tadesse, and R. Eswaramoorthy, “Review on manganese oxide based biocatalyst in microbial fuel cell:

Nanocomposite approach,” 2020. doi: 10.1016/j.mset.2019.11.001.

[7] V. G. Gude, “Wastewater treatment in microbial fuel cells – an overview - ScienceDirect,” 2016, Journal of Cleaner

Production.

[8] D. Bose, C. Kurien, A. Sharma, S. Sharma, and A. Sharma, “Low cost cathode performance of microbial fuel cell for

treating food wastewater,” Nat. Environ. Pollut. Technol., vol. 17, no. 3, pp. 853–856, 2018.

[9] P. Gadhave, R. Sasane, G. Wagh, N. Bhatt, and P. Sutar, “Electricity Generation from Dairy Farm Wastes In a DualChamber Microbial Fuel Cell Using Aluminium Electrodes,” Int. J. Recent Technol. Eng., vol. 8, no. 6, pp. 3445–3449,

2020, doi: 10.35940/ijrte.d8086.038620.

[10] A. Janicek, Y. Fan, and H. Liu, “Design of microbial fuel cells for practical application: A review and analysis of scaleup studies,” Biofuels, vol. 5, no. 1, pp. 79–92, 2014, doi: 10.4155/bfs.13.69.

[11] D. A. Jadhav, A. K. Mungray, A. Arkatkar, and S. S. Kumar, “Recent advancement in scaling-up applications of

microbial fuel cells: From reality to practicability,” 2021. doi: 10.1016/j.seta.2021.101226.

[12] H. Hiegemann et al., “Performance and inorganic fouling of a submergible 255 L prototype microbial fuel cell module

during continuous long-term operation with real municipal wastewater under practical conditions,” 2019. doi:

10.1016/j.biortech.2019.122227.

[13] X. Cai et al., “Microbiome and antibiotic resistome in bioelectrochemical toilets for onsite treatment of fecal sludge,”

2024. doi: 10.1016/j.watres.2024.121956.

[14] Z. He, “Development of microbial fuel cells needs to go beyond ‘power density,’” 2017. doi:

10.1021/acsenergylett.7b00041.

[15] A. Singh and A. Kaushik, “Sustained energy production from wastewater in microbial fuel cell: effect of inoculum

sources, electrode spacing and working volume,” 2021. doi: 10.1007/s13205-021-02886-6.

[16] H. J. Mansoorian, A. H. Mahvi, A. J. Jafari, and N. Khanjani, “Evaluation of dairy industry wastewater treatment and

simultaneous bioelectricity generation in a catalyst-less and mediator-less membrane microbial fuel cell,” 2016. doi:

10.1016/j.jscs.2014.08.002.

[17] Y. Dong et al., “A 90-liter stackable baffled microbial fuel cell for brewery wastewater treatment based on energy selfsufficient mode,” 2015. doi: 10.1016/j.biortech.2015.06.026.

[18] S. Wu et al., “A novel pilot-scale stacked microbial fuel cell for efficient electricity generation and wastewater

treatment,” 2016. doi: 10.1016/j.watres.2016.04.043.

[19] A. Vilajeliu-Pons, S. Puig, I. Salcedo-Dávila, M. D. Balaguer, and J. Colprim, “Long-term assessment of six-stacked

scaled-up MFCs treating swine manure with different electrode materials,” 2017. doi: 10.1039/c7ew00079k.

[20] P. Liang, R. Duan, Y. Jiang, X. Zhang, Y. Qiu, and X. Huang, “One-year operation of 1000-L modularized microbial

fuel cell for municipal wastewater treatment,” 2018. doi: 10.1016/j.watres.2018.04.066.

[21] C. Santoro et al., “Ceramic Microbial Fuel Cells Stack: Power generation in standard and supercapacitive mode,” 2018.

doi: 10.1038/s41598-018-21404-y.

[22] E. Dannys, T. Green, A. Wettlaufer, C. M. R. Madhurnathakam, and A. Elkamel, “Wastewater Treatment with Microbial

Fuel Cells: A Design and Feasibility Study for Scale-up in Microbreweries,” J. Bioprocess. Biotech., vol. 6, no. 1, pp.

1–6, 2016, doi: 10.4172/2155-9821.1000267.

[23] M. Lu et al., “Long-term performance of a 20-L continuous flow microbial fuel cell for treatment of brewery

wastewater,” 2017. doi: 10.1016/j.jpowsour.2017.03.132.

[24] M. A. Linares RV, Dom J, Rodr E, Patr G, Castillo-hern A, “Water _ Free Full-Text _ Scale up of Microbial Fuel Cell

Stack System for Residential Wastewater Treatment in Continuous Mode Operation,” 2018, Special Issue Microbial

Ecology of Full-Scale Wastewater Treatment Systems)

Downloads

Published

25-02-2025